Pavé is a setting in which many small stones are placed close together, creating a continuous sparkling surface. They are held by tiny metal beads or prongs. The word is French and means paved. As little metal as possible should be visible between the stones.
At a glance
- Type
- Setting for many small stones
- Origin of the word
- French pavé, paved
- Hold
- Small metal beads or prongs
- Effect
- Continuous sparkling surface
- Keep in mind
- Resizing is more difficult, occasional inspection is advisable
A surface of light
In pavé, the single stone steps back and the surface takes over. Stone is set beside stone, and small beads of metal hold each one at several points. For the surface to look calm, the stones must match precisely in size and color and sit at the same height. The work requires patience and a steady hand, and it belongs to the craft of stone setting.
What pavé means in daily wear
Many small stones mean many small points of hold. Pavé may therefore need an inspection from time to time to make sure every stone is secure. Rings with a set shank are also harder to resize, so the ring size should be right from the start. Pavé is used on ring shanks, around a center stone or across entire surfaces. How a single stone is held is explained in the entry prong setting.
Frequently asked questions
Are stones in a pavé setting less secure?
With careful work they sit securely. Because each stone is held only by small beads, however, every point of hold matters. GIA notes that pavé occasionally needs maintenance. Taking the ring off for rough work protects the setting.
Can a ring with pavé be resized?
Only to a limited extent. When the shank is enlarged or reduced, the spacing of the settings changes and stones can loosen. The further the stones run around the ring, the more difficult the change becomes. The ring size should therefore be determined carefully before the piece is made. Vikar Ahmed resizes rings where the design allows it, which is not possible with continuous pavé.
Which stones are suitable for pavé?
Above all small diamonds, because they are hard and sparkle vividly. Colored gemstones can also be set as pavé if they are uniform in size and hue. Consistency is what counts: even slight differences disturb the calm appearance of the surface. At Vikar Ahmed, pavé diamonds are matched to the center stone, in color D to G and clarity VVS to VS, uniformly cut and calibrated.
Private consultation
Stone setting is one of the steps Vikar Ahmed carries out in its own atelier. Whether a set surface suits your design can be clarified in conversation, in the showroom in Idar-Oberstein by appointment or virtually. Request a private consultation.
Further reading
Sources
- GIA: Guide to Engagement Ring Settings, accessed 2026-11-16
- Vikar Ahmed: Bespoke, accessed 2026-11-16

A personal conversation starts here.
At the showroom in Idar-Oberstein or by video. Vikar Ahmed discusses your ideas, stones and designs with you and answers your questions calmly and in confidence.
Thank you for your request.
Your request will be handled with the utmost attention and discretion. Vikar Ahmed will get back to you.
Your details
Request
–
Occasion
–
Consultation
–
Contact
–
In the meantime
Insights: What is a Paraíba tourmaline? · Engagement ring to your own design: how does it work?
Confidential and without obligation
Back to the page
Private consultation
A personal conversation starts here.
- Time for your questions, wishes and ideas
- In the showroom in Idar-Oberstein or by video
- Confidential, discreet and without obligation
Vikar Ahmed · Hauptstraße 111 · 55743 Idar-Oberstein, Germany

.webp)


.webp)
.webp)